Quick Start Guide

(Difference between revisions)

Revision as of 22:08, 23 September 2014

What you will need

To operate a HardWaves system, some items are required, other are helpful.

Required

• One HardWaves Surfer
• One or more HardWaves One board(s)
• A Small magnet
• A host system (Raspberry-PI or any other supported host)
• A computer with a WEB browser installed (we suggest Firefox or Chrome)

Not essential but helpful to have

• Internet connection

 To update or download software, we recommend that you connect your host system to the internet either via and ethernet cable or a wifi adapter.

Step 1 - Host Setup

A ready to use host system and a working Surfer can be setup following the following instructions.

How to build a HardWaves system

Step 2 - Surfer verify

Assuming that previous step is OK, check for Surfer operation:

1. if necessary, run your preferred WEB browser and open the "Wine" page on it
2. click (or tap) on "Enroll Nodes" tab
3. check for "Surfer:UP" under "Server Status"

Done.

Step 3 - Surfer setup

Assuming that previous step is OK, Surfer setup is quite simple:

1. click (or tap) on "Enroll Nodes" tab
2. enter 16 hex digits (0..9, a..f, case insensitive) to change the "Network Key" and confirm

This will set your own key, that will be shared by any node on the network.

If you change this key in the future, you will lose connection with existing nodes.

Step 3 - Enroll HardWaves One node(s)

To enroll ome or more HardWaves One node(s), you must set Surfer in "Enroll Mode":

1. choose mode, "Single Address" if you have just one node to enroll, "Multiple Adresses" if you want to enroll more than one node
2. set the address you want, e.g. 201
3. follow this