Login
Username:

Password:

Remember me



Lost Password?

Register now!
Who is Online
9 user(s) are online (8 user(s) are browsing Wiki)

Members: 0
Guests: 9

more...
[Main Page]

User Interface

Revision as of 14:31, 17 September 2014; pzebelloni (Talk | contribs)
(diff) ←Older revision | Current revision | Newer revision→ (diff)

Main Page | Recent changes | View source | Page history | Switch to MediaWiki mode

Printable version | Disclaimers | Privacy policy | Current revision

User Interface

Just one 2-colors LED (or a couple of RED/GREEN LEDs) and a Reed Switch (or a tactile button) provide a user interface for...

LED
Blinks
Command
ORANGE 1 Show status.
The LED blinks according to the module network link status for 10 seconds.
See Network diagnostics.
ORANGE 2 Test mode.
The device starts a test session, sending test frames to the Base Station every 5 seconds and the LED blinks according to the module network link status.
See Network diagnostics.
The module exits from test mode after 120 seconds. Show Status command stops the test procedure.
ORANGE 3 Enroll.
The network enroll procedure starts.
Command is valid only if the node is not enrolled yet.
After the command two leds blink accordingly to the module network link status.
ORANGE 4 Stop.
The device stops any network activity, putting hardware in a deep-sleep state.
ORANGE 5 Factory Default.
Restore the factory default parameters.

Network Diagnostics

LED color and blinks count report the radio signal levels.

LED
Blinks
Command
GREEN 1 to 5 Good.
Above -90 [dBm]. More blinks, better signal.
ORANGE 1 to 5 Weak.
Below -90 [dBm]. More blinks, better signal, but GREEN is better.
RED 1 long (2 [s]) Off-Line.
Node is enrolled but not synchronized on the network.
RED 1 Not Enrolled.
Node is not (yet) enrolled.