Login
Username:

Password:

Remember me



Lost Password?

Register now!
Who is Online
10 user(s) are online (5 user(s) are browsing Wiki)

Members: 0
Guests: 10

more...
[Main Page]

Firmware Update

From C-Labs Home

Main Page | Recent changes | View source | Page history | Switch to MediaWiki mode

Printable version | Disclaimers | Privacy policy

Contents

Hardware Requirements

A free USB port is required to update HardWaves devices.

Surfer

No additional hardware is required to update Surfer, since it directly connects to USB host port.

One - HW1

A USB-to-LVTTL UART cable is required.

A FTDI cable like TTL-232RG-VSW3V3-WE can be used, but requires a patch.

Using a sharp cutter, a part of plastic case has been removed, and brown wire has been moved on the pad shown in the image, between orange and green wires.

Any case, UART used signals are: RXD, TXD, RTS, DTR, GND and Power.

WARNING!!! A voltage of +3.3 [VDC] is required.

The image above shows HW1 Programming port. Odd pins ( #1, #3, #5) are in the bottom row, while even pins (#2, #4, #6) are in the top row.

Signals direction is indicated from the point of view of HW1 board.

One PIN#
Name
Mode / Direction
UART
Remarks
1 GND Power GND Power & Signal Reference
2 /RST IN DTR MSP RESET Signal
3 BSL_TX OUT RXD TX Data (ONE -> Host/PC)
4 TEST IN RTS MSP TEST Signal
5 BSL_RX IN TXD TX Data (One <- Host/PC)
6 VDD Power +3V3 +3.3 [VDC] Power Supply

Software

Since TI BSL may erase EEPROM Segment A, programming with standard utilities will brick One.

A dedicated software utility will be available for download together the first software update.

Retrieved from "https://www.c-labs-wt.com/modules/mediawiki/index.php?title=Firmware_Update"

This page has been accessed 11,338 times.

This page was last modified 16:39, 29 September 2014. Content is available under C-Labs Home.