User Interface
From C-Labs Home
Revision as of 14:31, 17 September 2014; pzebelloni (Talk | contribs)
(diff) ←Older revision | Current revision | Newer revision→ (diff)
(diff) ←Older revision | Current revision | Newer revision→ (diff)
User Interface
Just one 2-colors LED (or a couple of RED/GREEN LEDs) and a Reed Switch (or a tactile button) provide a user interface for...
| LED
| Blinks
| Command
|
|---|---|---|
| ORANGE | 1 | Show status. The LED blinks according to the module network link status for 10 seconds. See Network diagnostics. |
| ORANGE | 2 | Test mode. The device starts a test session, sending test frames to the Base Station every 5 seconds and the LED blinks according to the module network link status. See Network diagnostics. The module exits from test mode after 120 seconds. Show Status command stops the test procedure. |
| ORANGE | 3 | Enroll. The network enroll procedure starts. Command is valid only if the node is not enrolled yet. After the command two leds blink accordingly to the module network link status. |
| ORANGE | 4 | Stop. The device stops any network activity, putting hardware in a deep-sleep state. |
| ORANGE | 5 | Factory Default. Restore the factory default parameters. |
Network Diagnostics
LED color and blinks count report the radio signal levels.
| LED
| Blinks
| Command
|
|---|---|---|
| GREEN | 1 to 5 | Good. Above -90 [dBm]. More blinks, better signal. |
| ORANGE | 1 to 5 | Weak. Below -90 [dBm]. More blinks, better signal, but GREEN is better. |
| RED | 1 long (2 [s]) | Off-Line. Node is enrolled but not synchronized on the network. |
| RED | 1 | Not Enrolled. Node is not (yet) enrolled. |
